Description
Arduino Nano v3.0 (compatible) microcontroller. A low-cost small board with friendly mini USB connector. Functionally, it’s equivalent to Arduino Uno, Diecimila, Duemilanove.
Characteristics
- ATMEGA328
- Built-in LED in 13 pin.
- Analog inputs A0-A7.
- Transmission LEDs: TX green, RX red and L orange.
- ICSP connector.
- mini-B USB (drivers CH-340).
- 6 PWM pins.
- 14 I/O pins.
- Others: SPI, I2C.
- Pitch 0.1” DIP (compatible with breadboards).
- Automatic reset after code uploading and manual reset button.
Especifications
Microcontroller Atmel ATmega328
Operating Voltage (logic level) 5 V
Input Voltage (recommended) 7-12 V
Input Voltage (limits) 6-20 V
Digital I/O Pins 14 (of which 6 provide PWM output)
Analog Input Pins 8
DC Current per I/O Pin 40 mA
Flash Memory 32 KB (of which 2KB used by bootloader)
SRAM 2 KB
EEPROM 1 KB
Clock Speed 16 MHz
Dimensions 0.70” x 1.70”
Power
Arduino Nano v3.0 (compatible) can be powered through the mini-B USB connector (with a PC or USB powerbank) or with an external , non-regulated, power source withing the range 6-20V (30 pin) or with a 5V voltage regulator (27 pin).
