Actualmente la tienda está cerrada y los productos no estarán disponibles. Lamentamos cualquier inconveniente.

Arduino Nano v3.0 (compatible)

4.50 

Arduino Nano v3.0 (compatible)

SKU: ARDUINO_NANO-SIN_SOLDAR Category:

Description

Arduino Nano v3.0 (compatible) microcontroller. A low-cost small board with friendly mini USB connector. Functionally, it’s equivalent to Arduino Uno, Diecimila, Duemilanove. Pins are not soldered

Characteristics

  • ATMEGA328
  • Built-in LED in 13 pin.
  • Analog inputs A0-A7.
  • Transmission LEDs: TX green, RX red and L orange.
  • ICSP connector.
  • mini-B USB (drivers CH-340).
  • 6 PWM pins.
  • 14 I/O pins.
  • Others: SPI, I2C.
  • Pitch 0.1” DIP (compatible with breadboards).
  • Automatic reset after code uploading and manual reset button.

Especifications

Microcontroller                        Atmel ATmega328
Operating Voltage (logic level)  5 V
Input Voltage (recommended)  7-12 V
Input Voltage (limits)               6-20 V
Digital I/O Pins                        14 (of which 6 provide PWM output)
Analog Input Pins                    8
DC Current per I/O Pin            40 mA
Flash Memory                          32 KB (of which 2KB used by bootloader)
SRAM                                     2 KB
EEPROM                                 1 KB
Clock Speed                           16 MHz
Dimensions                            0.70” x 1.70”

Power

Arduino Nano v3.0 (compatible) can be powered through the mini-B USB connector (with a PC or USB powerbank) or with an external , non-regulated, power source  withing the range 6-20V (30 pin) or with a 5V voltage regulator (27 pin).

Additional information

Weight 0.1 kg
Dimensions 10 × 3 × 3 cm

You may also like…