NodeMCU V2 ESP8266 WiFi

6.00

NodeMCU V2 ESP8266 WiFi (Compatible with the NodeMCU v2 shield with motor driver).

9 in stock

SKU: NODEMCU_ESP8266-v2 Categories: ,

Description

NodeMCU v2 board it is based on ESP8266 processor. This is a processor widely used in IoT projects with integrated WiFi. It can be programmed in Lua, but it is possible to program it with Arduino IDE and Facilino too. It works at 3.3V. This board fits with the shield for NodeMCU v2 with a motor driver.

Description

  • USB chip CH340G.
  • Power: 4.5V~9V (10VMAX) and/or from USB.
  • I/O Power: 3.3V.
  • Wireless 802.11 b/g/n standard
  • WiFi at 2.4GHz, supports WPA/WPA2 encryption
  • WiFi operation mode: STA/AP/STA+AP
  • TCP/IP stack protocol (maximum 5 connections)
  • Pins: D0~D8, SD1~SD3 can be used as GPIO, PWM, I2C able to drain 15mA on each pin.
  • 1 ADC: AD0
  • Current consumption ≈ 70mA (200mA MAX), Standby: <200uA
  • Transmission rate: 110-460800bps
  • Communication UART supported.
  • OTA: Remote firmware upgrade
  • Supports Smart Link Smart Networking
  • Temperature range: -40 ℃~+125 ℃
  • Memoria: 4MByte

Additional documentation:

https://nodemcu.readthedocs.io/en/master/

Pinout

 

You may also like…